Set for sliding gates 600 kg mechanical switches KBULL624.TURBO.PM

Sliding gate drive for intensive residential use.Control unit with built-in receiver and encoder. Unlocking with a personal key. Up to 600kg

24Vdc actuator intensive use

• Opening time 25.5 m/min
• Built-in switching power supply (85/265 VAC) - reducing energy consumption,
• The receiver only remembers remote controls with an advanced and secure ARC code, up to 512 codes,
• When you start the drive for the first time, you can program the remote controls and perform the auto-learning procedure using a remote control with the ARC code,
• Actuator with built-in battery charging card - does not require BULL24.CBY - two DA.BT2 batteries are enough,
• The integrated STC system combined with a virtual encoder allows you to adapt the actuator operation to the prevailing conditions, ensuring maximum safety and thus eliminating accidental operation of the amperometric system,
• Safety of use is ensured by low voltage and a phototest function that checks the operation of safety systems at the beginning of each maneuver,
• During unlocking, the safety sensor cuts power to the motor to ensure the system is properly reactivated after maintenance is completed.
• The brake is controlled using MOSFET technology (a transistor instead of a relay), which ensures smooth operation, eliminating the expansion of the braking space at higher temperatures,
• It is possible to integrate with the KNX system,
• Equipped with cable mounting holders,
• Built-in housing for 2 batteries,
• The cable entry is protected against access by small animals,
• Easy wired synchronization of 2 BULL624 TURBO actuators is enabled by SIS cards

• Power supply: 230 Vac (50-60Hz)
• Motor power supply: 24 Vdc
• Current: 3A
• Power consumption in idle state: 8 mA
• Maximum force: 330N
• Opening time: 12.5-25.5 m/min
• Duty cycle: 1050 cycles/day (in optimal working conditions),
• Degree of protection: IP44
• Magnetic switches: NO
• Operating temperature: -20℃ / +50℃
• Maximum gate weight: 600kg
• Outer wheel module: M4 Z18
• Weight: 10.6kg

Composition of the set you are purchasing:

• ActuatorBeninca BULL624 TURBO24Vdc with built-in control panel and receiver.
• A set of photocellsBeninca PUPILLA.T
• 2-channel remote controlBeninca TO.GO2VA433,92MHz
• Mounting accessories
• Instructions in Polish