SOLAR BATTERY CHARGING REGULATOR SCC-100A-PWM-LCD-S2

Photovoltaic panels are a clean and ecological source of electricity

Obtaining this energy, however, poses a number of challenges to device designers

The amount of energy produced by the panel is strongly dependent on the angle of incidence and the intensity of light falling on the surface of the cells

This, in turn, leads to unstable power supply parameters at the output, because even shading a small part of the panel may result in a drastic reduction in efficiency.

The optimal solution to the above-mentioned problems is to use a set consisting of a photovoltaic panel, a battery and a charging controller

This set allows you to ensure constant power supply parameters for receivers, and also store excess energy produced for later use

The SCC-100A-PWM-LCD-S2 solar controller allows you to connect panels connected to each other both in series and in parallel - remembering not to exceed the permissible current and voltage values ​​at the device input.

Attention!

Solar controllers are designed to work with photovoltaic panels. They should not be used with other power sources