Paradox Day to Day: What's Actually Yours to Control
An alarm system runs every day, but not every setting is yours to touch. Here's a clear picture of what a Paradox user can handle solo — and where the installer's job begins.
What daily use looks like
Arming and disarming
Punch in your code at the keypad or a TM70/TM50 touchscreen, or arm/disarm remotely through the Insite Gold app if an IP or GSM module is connected to the panel.
Checking zone status
The keypad or app shows which zones are open, closed, or have triggered an alarm — so you can check everything's fine before arming.
Battery and comms alerts
The system flags it when a sensor's battery is low or a comms link drops — that's your cue to act, not ignore.
Test-arming after changes
After any change your installer makes, do a test arm to confirm everything's working the way it should.
What's in your hands (and what isn't)
ways to arm the system
Keypad, touchscreen, or app — pick whatever's handiest in the moment.
Arm/disarm
By code, card, or remotely — the everyday basics are entirely up to you.
Zone overview
See which doors, windows, or motion sensors are active, right from the keypad or app.
Battery swaps
Replacing keypad and panel backup batteries on schedule is your job, and it's simple.
Insite Gold remote control
With an IP150 or GSM module in place, you can check in and control the system from your phone, anywhere.
Adding zones or PGM outputs
That stays with a certified installer, working through the keypad or BabyWare software — not a DIY job.
When to call your installer
Some jobs were, and still are, the professional's territory.
- Adding new zones
- Changing PGM output logic
- Full system reprogramming
- Changing codes or user structure
- BabyWare configuration
Frequently asked questions
Can I arm or disarm the alarm remotely myself?
Yes, as long as the panel has an IP or GSM/mobile module connected and Insite Gold is set up — without that module, the app doesn't work.
Can I add a new zone or sensor myself?
No, adding and configuring new zones is a certified installer's job, usually done through the keypad or BabyWare software.
How do I know a battery needs replacing?
The keypad or app shows a low-battery or comms-fault warning — that's your signal to act.
What are TM70 and TM50?
They're Paradox touchscreen keypads that give a more visual overview of zone status and easier daily control than a standard LED/LCD keypad.
Can I change PGM output settings myself?
No, PGM output logic — like relay or gate control — is part of system programming and stays with the installer.
Interested in Paradox solutions?
Browse the products in our shop, or get in touch if you need advice.